



Contact Ultrasonics & Inspection Consulting performs upstream and downstream industrial inspections to provide our clients with quick, accurate, & reliable information along with the documentation for records of all inspections performed to ensure code compliance. All inspections are performed by American Welding Society Certified Welding Inspectors (AWS / CWI), American Society For Nondestructive Testing Level III technicians, or Level II technicians certified by company procedures that meet the requirements of ASNT recommended practice SNT-TC-1A. Reports can be completed and delivered electronically or handwritten.
Our technicians have many years of field experience performing structural integrity, safety, and nondestructive inspections in industries including:
Drilling Rigs (Land & Offshore) – Contact Ultrasonics performs API-4G inspections on masts or derricks, and API-Section 8 inspections on drilling tools by the American Petroleum Institute recommended practices. We perform structural integrity inspections, looking for stress cracking, on all drilling rig components including the mast/derrick, substructure, high-pressure mud lines, mud pumps, mud tanks, shaker skid, etc. We also perform safety inspections for OSHA compliance.
Chemical & Petrochemical Plants: Contact Ultrasonics performs On-Stream and Turnaround / Outage NDT inspections, for the plant inspection department or maintenance contractors, on various components including (but not limited to) piping, pressure vessels, heat exchangers, and storage tanks.

Visual inspection is one of the most utilized and proficient methods of non-destructive testing available. All visual inspections are conducted by certified inspectors with vast knowledge and experience in his/her field. Visual Inspections may be performed using the direct or indirect method. Examples of indirect visuals may include bora scope, remote video, etc.

Ultrasonic Flaw Detection is a non-destructive testing procedure in which beams of high-frequency sound waves are used to detect surface and sub-surface flaws. The sound waves travel through the materials, then, are then reflected at metal interfaces capable of revealing discontinuities. With this test, the technician can determine the presence and location of imperfections such as cracks, shrinkage, cavities, bursts, pores, non-fusion, and other defects. This test is used for quality control and materials testing in all major industries. Ultrasonic flaw testing procedures include testing of forgings, castings, rolled plates, weld joints, and steel production. UT technicians also perform inspections on fabricated structures such as pressure vessels, pipelines, drilling rigs, ships, and other steel components. Flaw detection techniques include:

Ultrasonic testing can also be used to measure the thickness of metal sections during manufacturing and maintenance inspections. Conventional UT is accurate, fast, and relatively inexpensive. These tests employ a transducer that emits ultrasonic pulses into the material which are then reflected to the transducer from the back wall of the material. Using calibration standards, material thickness can be accurately tested to within thousands of an inch. With the use of phased array equipment, corrosion scans can be performed and recorded electronically. Corrosion scans show a color scale picture of the scanned parts back wall, such as pits and wash-out areas.

Magnetic Particle Testing is a non-destructive testing (NDT) method of locating surface and near-surface defects in ferromagnetic materials. When materials or parts are MT tested, they temporarily become magnetized causing discontinuities to emit a stronger magnetic field called flux leakage. When finely divided ferromagnetic particles are applied to the part, they group at the flux leakage revealing the discontinuity. The technician can determine the length and location of the indications by viewing the particle groupings. Magnetic Particle Testing can be used to detect casting, forging, and welding flaws such as cracks, seams, and surface-breaking lamination.

Brinell Hardness testing ascertains a material resistance to indentation. Hardness is determined by comparing the indention diameter in the test material with the indentation diameter in a known hardness bar after an indenter strikes the material surface. This helps to average out surface and sub-surface inconsistencies. This test is most commonly used on materials that have a structure that is too coarse or that has a surface that is too rough to be tested using another method.